Components for Electric Motors and Generators

Lamination Stacks

Lamination stacks are packages using single laminations separated by electrical insulating layers to surpress eddy current losses during dynamic magnetic load.

In-house manufactured cobalt-iron or nickel-iron strips in combination with adjusted production technologies are offering optimum stack solutions with respect to performance and costs.

These parts are mainly used as stators and rotors in electric motors and generators but also as laminated cores.

Learn More

17 % Cobalt-Iron - VACOFLUX X1

VACOFLUX® X1 was specifically developed for the use in electric motor applications and to close the gap between silicon-iron and 49 % cobalt-iron alloys. Motors using the 17 % cobalt-iron alloy VACOFLUX X1 will be considerably better performing than with electrical steel, however they will also be considerably cheaper than motor designs based on 49 % cobalt-iron. 

49 % Cobalt-Iron VACOFLUX and VACODUR

Thanks to their high magnetic saturation of up to 2.4 T, the cobalt-iron (CoFe) alloys VACOFLUX® and VACODUR® are generally suitable for all applications where high flux density and minimum weight are required.

Qualities with a cobalt content of 49 % and 2 % vanadium are offering in addition low coercivity forces and therefore best possible parameters for highest performance electric motors/generators and magnetic actuators.

With adapted annealing temperatures, the VACODUR alloys can be used to satisfy demanding strength requirements, e.g. for high speed rotations.

Learn More

9 to 27 % Cobalt-Iron VACOFLUXCost Optimized Cobalt-Iron Alloys have the Highest Saturation Polarization of all known Magnetic Alloys.

Cobalt-Iron alloys in general have a very high polarization saturation. This group of CoFe alloys, with a reduced cobalt content of 9 % to 27 % cobalt, are optimized to meet the requirements of technically demanding, however cost sensitive applications.

Learn More

Magnet Assemblies

We are your reliable partner when it comes to the development and production of a wide range of magnet assemBLIes. The positioning of magnets with extreme precision, especially small one, and the very high forces associated with large-volume magnetized parts, make the assemBLIng of magnet systems a challenging task. For this process we can apply our extensive experience in the design and construction of assembly tools and our expert knowledge in the selection of a suitable bonding process.

Learn More

NdFeB – VACODYMRare Earth Permanent Magnets for Highest Energy Density Requirements.

VACODYM® permanent magnets are produced on the basis of neodymium-iron-boron alloys and have the highest energy density available today. VACODYM alloys are anisotropic material grades.

Learn More

SmCo – VACOMAXRare Earth Permanent Magnets for High Temperature Applications.

VACOMAX® is our permanent magnet material made from rare earths and cobalt.

These magnets have particularly high coercivities with simultaneous high saturation polarization and excellent temperature and corrosion stability.

Learn More

40 to 50 % Nickel-IronPERMENORM

Alloys with a Ni-content of around (40 to 50) wt% are characterized by a maximum in the saturation polarisation of up to JS = 1.6 T and a medium range permeability. By selecting appropriate rolling and annealing conditions, the shape of the magnetization curve can be varied over a wide range.

Learn More

Soft Magnetic Stamped Parts

All crystalline alloys can be processed further to stamped parts. VAC has state-of-the-art facilities for punching, deep-drawing and further processing methods like interlocking or wire-EDM.
 

Learn More